Kenmore 385.12618 Owner's Manual page 2

IMPORTANT SAFETY INSTRUCTIONS
Your sewing machine is designed and constructed only for HOUSEHOLD use
Read all instructions before using this sewing machine,.
DANGER- To
r educe the risk of electric shock:
1. This sewing machine should never be left unattended when plugged in. Always unplug this sewing machine from the
electric outlet immediately after using and before cleaning,
2, Always unplug before replacing a sewing machine bulb. Replace bulb with same type rated 15 Watts
3_ Do not reach for a sewing machine that has fallen into water Unplug immediately.
4. Do not place or store this sewing machine where it can fall or be pulled into a tub or sink Do not place or drop it into water
or other liquid.
WAR N IN G - To reduce the risk o f b urns, fire, electric
shock, or injury
to persons:
1. Do not allow this sewing machine to be used as a toy Close attention is necessary when this sewing machine is used by
or near children.
2. Use this sewing machine only for its intended use as described in this owner's manual.
Use only attachments recommended by the manufacturer as contained in this owner's manual
3 Never operate this sewing machine if it has a damaged cord or plug, if it is not working properly, if it has been dropped
or damaged, or dropped into water
Return this sewing machine to the nearest Sears store or service center for examination, repair, electrical or mechanical
adjustment
4 Never operate this sewing machine with any air opening blocked Keep ventilation openings of this sewing machine and
foot controller free from accumulation of lint, dust and loose cloth..
5. Never drop or insert any object into any opening
6_ Do not use outdoors,
7 Do not operate where aerosol (spray) products are being used or where oxygen is being administered.
8. To disconnect, turn all controls to the off ("0") position, then remove plug from outlet.
9. Do not unplug by pulling on cord. To unplug, grasp the plug0 not the cord.
1Q Keep fingers away from att moving parts. Special care is required around the sewing machine needle,.
tl. Always use the proper needle plate The wrong plate can cause the needle to break
12. Do not use bent needles.
13. Do not pul! or push fabric while stitching. It may deflect the needle causing it to break.
14. Switch this sewing machine off (" 0") when making any adjustment in the needle area, such as threading the needle,
changing the needle, threading the bobbin or changing the presser foot, and the like.
154 Always unplug this sewing machine from the electrical outlet when removing covers, lubricating, or when making any
other adjustments mentioned in this owner's manual.
SAVE THESE INSTRUCTIONS
When using your sewing machine for the first few times, place a waste fabric under the presser foot and run
the machine without thread for a few minutes,. Wipe away any oil which may appear.
',"1