Network Configuration - Fujitsu PRIMERGY TX200FT S2 Start Manual

Table of Contents

Advertisement

n Validation interval at automatic shutdown
This setting
required for the use of UPS.
For details about various settings, refer to "3.4 UPS Settings" in the "User's Guide". The numbers in brackets ( ) are setting
examples.
Item
Validation interval from the power failure
to the start of FTvirtual Server shutdown
Validation interval from the start of FTvirtual
Server shutdown to the start of CoServer
shutdown (Command file execution time)
Validation interval from the start of CoServer
shutdown to UPS power off (time required for
OS shutdown)
n Network configuration
CoServer Link1, CoServer Link2, Virtual Network1 and Virtual Network2 are internal network settings. Normally modifi-
cations are not required.
However, when there is a conflict with an external network, refer to "3.2 Network Functions" in the "User's Guide" before
setting. Figures in the brackets ( ) are default values.
Item
Computer name
Local area connection (FTvirtual Server LAN)
Virtual Network1
Virtual Network2
Item
Computer name
CoServer Management
(CoServer LAN)
CoServer Link1
CoServer Link2
Virtual Network
When setting, the FTvirtual Server LAN adapter appears (Redirected 0) on the CoServer, but it is reserved because it is
used by the FTvirtual Server.
Do not bind internet protocol (TCP/IP) and do not set IP addresses or subnet masks to these adapters on the CoServer.
Set the FTvirtual Server LAN IP address and the subnet mask on the FTvirtual Server.
"Power Failure" - "When power fails, begin a shutdown
procedure:" - "After UPS has been on battery for" in
Device Properties.
Select Device properties "Shutdown Sequence" -
"Configure Shutdown Sequence" - "Next" - "OS" and
then "Delay".
Select Device properties "Shutdown Sequence" -
"Configure Shutdown Sequence" - "Next" - "OS" and
then "Duration".
Total
CoServer1 (FT1)
IP address
.
.
.
(192 .168 .181 . 89)
(255 .255 .255 .252)
(192 .168 .181 . 93)
(255 .255 .255 .252)
(192 .168 .181 . 82)
(255 .255 .255 .252)
Actual Setting Parameters
FTvirtual Server
IP address
.
.
.
(192 . 168 . 181 . 81)
(192 . 168 . 181 . 85)
Subnet mask
IP address
.
.
.
(192 .168 .181 . 90)
(192 .168 .181 . 94)
(192 .168 .181 . 86)
6
(1 min)
(3 mins)
(1 minute
30 seconds)
(5 minutes
30 seconds)
Subnet mask
.
.
(255 . 255 . 255 . 252)
(255 . 255 . 255 . 252)
CoServer2 (FT2)
Subnet mask
.
.
.
.
(255 .255 .255 .252)
(255 .255 .255 .252)
(255 .255 .255 .252)
Time
minutes
minutes
minutes
minutes
seconds
.
.
.

Advertisement

Table of Contents
loading

Table of Contents