Table of Contents
Advertisement
5
Click [Yes].
CoServer restarts.
After restarting, the POST screen (or
"PRIMERGY" logo) appears.
nRunning mini-setup of the CoServer2
The running mini-setup procedure is the same as for CoServer1. Press the power switch on the front of
FT2 and turn on the power supply. For details about further operations, refer to "nRunning mini-setup
of the CoServer1" and run mini-setup.
nRunning mini-setup of the FTvirtual server
1
Turn on the power supply of FT1 and
FT2.
After POST has finished, the OS selection window
appears.
��������������������������������������������
�������������������������
��������������������������
��������������������������������������������������������������������
����������������������
�����������������������������������������������������������������
�����������������������������������������������������������������������
2
Check that "Online Endurance CoServ-
er" has been selected and press the
[Enter] key.
The logon window appears.
If the above operations are not performed, after a
temporary stop (30 secs) it begins to operate as the
"Online Endurance CoServer". It is fine to move on
to the next operation.
3
Enter the administrators privileges
password in FT1 and logon to CoServ-
er1.
The following window appears.
�����������
�����
6
When the server restarts, press the
power switch on the front of the server
straight away and turn off the power
supply.
4
Click [Start] " [All Programs] " [Mara-
thon Endurance] " [Management Tasks]
" [FTvirtual Server] " [Start] in CoServ-
er1 in this order.
The start window of Windows setup wizard ap-
pears.
Nothing is displayed on the Endurance FTvirtual
Server Desktop momentarily, but this does not indi-
cate an error. Please wait for a short while.
5
Click [Next].
Start setup. During setup enter the following pa-
rameters. All other parameters are optional. After
checking the parameter setting values, click [Next].
- License Agreement
- Personalize Your Software
(Name, organization)
- Computer name & Administrator password
- Date and Time Settings
When setup is complete, the FTvirtual Server re-
starts and the logon window appears.
6
Logon to FTvirtual Server.
7
Start Endurance Manager.
Click [Start] " [All Programs] " [Marathon En-
durance] " [Manager] to start Endurance Manager.
If the FTvirtual Server LAN cable is not connected
to the HUB, an error, as shown in the figure above,
will be displayed but this does not indicate an error.
Continue operations.
8
Advertisement
Table of Contents
