Unpacking Instructions; Tools Needed For Assembly - Emerson CF955BS 00 Owner's Manual

This Manual Is Designed to Make it as Easy as Possible for You to
Assemble, Install, Operate and Maintain Your Ceiling Fan

Tools Needed for Assembly

One Phillips head screwdriver
One 1/4" blade screwdriver
Three wire connectors (supplied)
One 3/16" hex wrench (supplied)
MATERIALS
Wiring outlet box and box connectors must be of type
required by the local code. The minimum wire would
be a 3-conductor (2-wire with ground) of the following
size:
For your convenience, check-off boxes are provided next to each step. As each step is
completed, place a check mark in the box. This will insure that all steps have been
completed and will be helpful in finding your place should you be interrupted.
!
Do not install or use fan if any part is damaged or
missing. Call Toll-Free:
1-800-654-3545
!
This product is designed to use only those parts
supplied with this product and/or any accessories
designated specifically for use with this product by
Emerson Electric Co. Substitution of parts or
accessories not designated for use with this product
by Emerson Electric Co. could result in personal
injury or property damage.
1. Check to see that you have received the following
parts:
NOTE: If you are uncertain of part description,
refer to exploded view illustration.
a. Fan motor assembly
b. One lower housing assembly
c. One ceiling cover
d. Five fan blades
e. One hanger ball/downrod assembly
f. One hanger bracket
g. One glass globe
h. One fan/light control
i. One coupler cover
j. Four 13-watt GU-24 fluorescent lamps
k. One loose parts bag containing:
1. Sixteen 3/16-24 x 1/2" slotted Phillips
washer head blade screws
2. Three wire connectors
3. Two 1-1/4" threaded studs
4. Two lockwashers
5. Two knurled knobs
6. One clevis pin
7. One hairpin clip
NOTE: Place the parts from the loose parts bags
in a small container to keep them from being lost.
If any parts are missing, contact your local retailer
or catalog outlet for replacement before
proceeding.
One stepladder
One wire stripper

Unpacking Instructions

WARNING
WARNING
Installed Wire Length
Up to 50 ft.
50-100 ft.
!
Before assembly your ceiling fan, refer to section on
proper method of wiring your fan (page 6). If you feel
you do not have enough wiring knowledge or
experience, have your fan installed by a licensed
electrician.
2. Remove the fan assembly from the protective
plastic bag. Place the fan assembly into the upper
foam pad with the top of the motor facing up.
The upper foam pad serves as a holder for the fan
during the first stages of assembly.
3
Wire Size A.W.G.
14
12
WARNING
COUPLER
COVER
FAN
ASSEMBLY
HANGER BALL/
DOWNROD
ASSEMBLY
GLASS
BOWL
13W GU-24
FLOURESCENT
LAMPS
LOWER
HOUSING
ASSEMBLY
3 4
2 5
1 6
FAN BLADES
U.L. Model No.: CF955
HANGER
BRACKET
CEILING
COVER
LOOSE
PARTS
BAG
FAN/LIGHT
CONTROL