Connecting Speakers - Yamaha DSP-E492 Owner's Manual

CONNECTING SPEAKERS

Right
Rear speakers
How to Connect to the REAR and CENTER SPEAKERS terminals
Connect the SPEAKERS terminals to your speakers with wire of the proper gauge, cut as short as possible. If the connections are
faulty, no sound will be heard from the speakers. Make sure that the polarity of the speaker wires is correct, that is the + and –
markings are observed. If these wires are reversed, the sound will be unnatural and lack bass.
Caution
Do not let the bare speaker wires touch each other and do not let them touch any metal part of this unit. This could damage
this unit and/or speakers.
Note
Use speakers with the specified impedance shown on the rear of this unit.
Red: positive (+)
Black: negative (–)
2
1
3
12
Left
Amplifier
(for driving main speakers)
Left
Unscrew the knob.
Insert the bare wire.
[Remove approx. 5mm
(1/4") insulation from
the speaker wires.]
Tighten the knob and
secure the wire.
Main speakers
Right
(Europe model)
MAIN
CENTER SINGLE:4 MIN./SPEAKER
DUAL:2 MIN./SPEAKER
REAR 6 MIN./SPEAKER
CENTER SINGLE:8 MIN./SPEAKER
DUAL:4 MIN./SPEAKER
REAR 8 MIN./SPEAKER
IMPEDANCE SELECTOR
CAUTION
SEE INSTRUCTION MANUAL FOR CORRECT SETTING.
REAR
CENTER
DUAL DUAL
SINGLE
OUTPUT SPEAKERS
Center speaker
<
General model only
Banana Plug connections are also possible. Simply insert the
Banana Plug connector into the corresponding terminal.
Subwoofer system
SUB
REAR CENTER WOOFER
l0 dB 0 dB
(SURROUND) DUAL DUAL
MAIN
OUTPUT LEVEL
>