Connections - Yamaha DSP-E492 Owner's Manual

REAR PANEL PARTS AND THEIR FUNCTIONS
1
MAIN CENTER
6CH DISCRETE
INPUT
SUB
WOOFER
VIDEO SIGNAL
AUDIO SIGNAL
1 2
CD TUNER
(LINE 1) (LINE 2)
8
1
6CH DISCRETE INPUT terminals
Connect a Dolby Digital (AC-3) Decoder to these terminals.
6-channels (left main, right main, center, left rear surround,
right rear surround and subwoofer) of discrete audio signals
with the Dolby Digital (AC-3) decoded are input to these
terminals from the decoder.
2
INPUT (from AMP/RECEIVER PREOUT) terminals
These are additional 6-channel audio signal input terminals (for
left main, right main, center, left rear surround, right rear
surround and subwoofer channels) available for inputting
signals from your existing amplifier, receiver, sound processor,
etc. to this unit.
To listen to a sound by reproducing signals input to these
terminals from the external amplifier etc., be sure to set the
PROCESSOR SELECTOR switch on the front panel to the
"EXTERNAL" position. By doing so, the signals input to these
terminals are sent to the corresponding SPEAKERS terminals
and OUTPUT terminals of this unit bypassing any circuit in this
unit. So, volume, tone, etc. must be controlled on the external
amplifier.
3
MAIN OUTPUT terminals
Main-channel line output. Connect these to input terminals of
external stereo power amplifier (MAIN IN or equivalent
terminals of integrated amplifier or receiver) driving the main
speakers.
8

CONNECTIONS

2
REAR MAIN CENTER REAR MAIN
INPUT
from
AMP/RECEIVER
PREOUT
SUB
(SURROUND) WOOFER (SURROUND)
MONITOR
IN OUT
OUT DVD/LD TV/DBS VCR
TAPE REC
3 4 IN OUT
PB OUT
VCR
TAPE DVD/LD TV/DBS
( MD )
INPUT OUTPUT
9 0
PROCESSOR
SELECTOR
INTERNAL
EXTERNAL
3 4
CENTER SINGLE:8 MIN./SPEAKER
DUAL:4 MIN./SPEAKER
REAR 8 MIN./SPEAKER
CENTER
SINGLE:4 MIN./SPEAKER
DUAL:2 MIN./SPEAKER
REAR 6 MIN./SPEAKER
IMPEDANCE SELECTOR
CAUTION
SEE INSTRUCTION MANUAL FOR CORRECT SETTING.
REAR
CENTER
DUAL DUAL
SINGLE
SPEAKERS
A
4
IMPEDANCE SELECTOR switch
Select the position whose requirements your speaker system
meets.
Be sure to switch this only when the power of this unit is turned
off.
Center: If you use one center speaker, the impedance of
Rear:
Center: If you use one center speaker, the impedance of
Rear:
WARNING
Do not change the IMPEDANCE SELECTOR switch
setting while the power to this unit is on, otherwise this
unit may be damaged.
5
SUB
REAR CENTER WOOFER
l0 dB 0 dB
(SURROUND) DUAL DUAL
MAIN
OUTPUT
LEVEL
B C D
(Right position)
the speaker must be 8 or higher.
If you use two center speakers, the impedance of
each speaker must be 4 or higher.
The impedance of each speaker must be 8 or
higher.
(Left position)
the speaker must be 4 or higher.
If you use two center speakers, the impedance of
each speaker must be 2 or higher.
The impedance of each speaker must be 6 or
higher.
6 7
MAINS
I00W MAX.
SWITCHED
AC OUTLET
(Europe model)