Advertisement
4. Withthehelpof
a second person, carefully lower the Left
and Right Updghts (1, 44) until the handrails are resting
on the floor.
.
Attach six Base Pads (57) to the bottom of the Base (59)
in the indicated locations. Note: One extra Base Pad
may be included.
See drawing 4 above. With the help of a second person,
raise the Left and Right Updghts (1, 44) until the Base
(59) is resting flat on the floor.
Before moving the treadmill, see HOW TO MOVE THE
TREADMILL on page 11.
.
Insert two Resistartce Bracket Bolts (107) with Bracket
Washers (70) into the Left Updght (1). Slide two Star
Washers (103), a Spacer (106), and two more Star
Washers (103) onto the Bolts. Make sure that the
Spacer is turned so the widest side is facing the Left
Upright. Tighten the Bolts into the Resistance Bracket
(104) at the lower end of the left Upper Body Arm (96).
Note: It may be necessary to loosen the Resistance
Knob (97) and pivot the Resistance Bracket.
Attach the right Upper Body Arm (96) as descdbed
above. Make sure that both Upper Body Arms are on the
correct side of the Console Base (9) as shown.
See drawing 2 on page 5. Feed the slack Wire Harness
(25) into the Base (59).
7. Remove the backing from the Adhesive Clip (77). Press
the AdhesiVe Clip onto the Rear Roller Endcap (78) in the
indicated location. Press the Allen Wrench (76) into the
Adhesive Clip.
Make sure that all pads are tightened before you use the
treadmill. Note: To protect the floor or carpet, place a
mat under the treadmill. For informatlon on ordering a
mat, see REPLACEMENT
PARTS on the back cover.
4
5
7
44
78
t<
76
Advertisement
