Static Configuration - Acer Ferrari 3400LMi Manual

F8­x86_64 on the Acer Ferrari 3400LMi
"Dialup Networking" (0x1103)
Protocol Descriptor List:
"L2CAP" (0x0100)
"RFCOMM" (0x0003)
Channel: 4
Language Base Attr List:
code_ISO639: 0x656e
encoding: 0x6a
base_offset: 0x100
Profile Descriptor List:
"Dialup Networking" (0x1103)
Version: 0x0100
To use the phone as a modem the service of interest is the Dial­up Networking, so
note its channel number.
The next step will be to create a virtual serial device and connect it to your phone:
# rfcomm connect 1 00:0A:D9:E9:D8:4F 4
Connected /dev/rfcomm1 to 00:0A:D9:E9:D8:4F on channel 4
Press CTRL­C for hangup
A short explanation of the command above:
rfcomm connect 1 00:0A:D9:E9:D8:4F 4
| | |
/dev/rfcomm1 _| | |_ Channel for the Dial­up
Your phones Networking service
That is about it. Now your phone is analogue to an external modem connected
to your virtual serial device, /dev/rfcomm1. Configure ppp to make use of it
and you are done.

13.2.3 Static configuration

Ok, now what? Do I need to repeat all the steps above each time I want to use my
phone as a modem? No, for convenience you may configure your system for all
this to take place automatically. However, the method you should use depends a
bit on your phone.
The preferred method is to edit the rfcomm.conf file so a /dev/rfcommX port
automatically binds to the DUN service on your phone when the bluetooth service
starts. This means that the virtual serial device will be created and properly
configured, but not connected. The actual connection will happen automagically
when the virtual serial device is accessed.
Edit the file /etc/bluetooth/rfcomm.conf to contain a section similar to this:
rfcomm1 {
# Automatically bind the device at startup
bind yes;
bluetooth address
30