GE Monogram ZGU36K Owner's Manual page 15

NOTE: B_,]bre _wnoving" the burr_er caps and
head,s, remember their size and location. Replace
them in the same lo_ation <(tier ch+aning'. The
burner head,s and burner ba,s_ are labeh+d B, C,
D and H to aid _wt,ssemb@
Burner caps
I,ifl off when cool. Wash burner caps in hot,
soapy water and rinse with clean water. You may
scour with a plastic scouring pad to remove
bm'ned-on fl>od particles.
Burner heads
The slits in the burner heads qf your _ooklop must lie
hept c&an at all time, L/br an even, unhampered
j[tl llze,
You should clean the bm'ner caps, bm'ner
heads and bm'ner bases routinely, especially
atter bad spillovers, which could clog the
openings in the bm'ner heads, i,ifl off when
COO1,
To remove burned-on tood, soak the bm'ner
heads in a solution of mild liqtfid detergent
and hot water for 20-30 minutes. For more
stubborn stains, use a toothbrush.
After cleaning"
geti>re putting the burner caps and heads
back, shake out excess water and then dry
them thoroughly by setting in a warm oven ti>r
30 minutes.
Replacement
The bm'ner heads and bm'ner bases are labeled
B, C, D and H to aid reassemblv:
Medium Small Small
head head head
and cap and cap and cap
(_c Front of cooktop D(_
Large Extra
head large
and cap head
and cap
Replace the burner heads on the bases
matching the letters. Replace the caps on the
heads. Make sure that the caps and heads are
replaced in the correct location. There are two
small (H), one medimn (B), one large (C) and
one extra large (D) head and cap.
Locate[
pins
Pin slots
When replacing, make sure the Iocator pins in the burner head
are seated in the pin slots of the burner base. Rotate the burner
head around the burner base until it is level and securely seated,
15