Using The Remote Control Unit - Sanyo SAP-KRV123EH Technical & Service Manual

SENSOR button
Temperature Display Selector
Time Display Selector button
ACL button (ALL CLEAR)
ADDRESS switch
The remote control unit sends the temperature signal to the air conditioner regularly at five minute
NOTE
intervals. If the signal from the remote control unit stops for more than 15 minutes due to the loss of
the remote control unit or other trouble, the air conditioner will switch to the temperature sensor which
is built into the indoor unit and control the room temperature. In these cases, the temperature around
the remote control unit may differ from the temperature detected at the air conditioner's position.
How to Install Batteries
10
Remote Control Unit (continued)
When you press this button (use a small-tipped object such as a ballpoint
pen), the mark will appear at the display. And the room temperature is
detected by the sensor which is built into the indoor unit and the air
conditioner is controlled accordingly.
If the remote control is located near a heat source, such as a space heater or
NOTE
in direct sunlight, press the SENSOR button to switch to the sensor on the
indoor unit.
This switches the temperature display between °C and °F.
button
This switches the time display between 24-hour time and 12-hour time.
Puts the remote control unit into pre-operation status. Always press this
button after replacing the batteries.
• The address switch changes to prevent mixing of signals from remote
control units when two air conditioners are installed next to each other.
Normally, the address switch is set to A. For more information, please
contact the dealer where you made the purchase.
• Normally, the tabs on the remote control unit should not be bent.

Using the Remote Control Unit

ACL button
• The batteries last about six months, depending on how much you
NOTE
use the remote control unit. Replace the batteries when the remote
control unit's display fails to light, or when the remote control cannot
be used to change the air conditioner's settings.
• Use two fresh leak-proof type-AAA alkaline batteries.
• In replacing batteries, follow the instructions as mentioned in the
sub-section "How to Install Batteries".
• If you do not use the remote control unit more than 1 month, take out
the batteries.
1. Slide the cover in the direction
indicated by the arrow and remove it.
2. Install two AAA alkaline batteries.
Make sure the batteries point in the
direction marked in the battery
compartment.
3. Use a thin object such as the tip of a
pen to press the ACL button.
OI-671-10-EG