Table of Contents
Advertisement
TEMPERATURE RECORDER (Option)
8. Remove the sensor cover at the rear of the chamber wall.
(Fig. 4)
9. Pass through the hole under the temperature control sensor. (Fig.
5) Tool for the hole: Screw driver (example) Hole depth:
135mm (5.3inch) Hole diameter: 13mm (0.5inch)
10. Route the recorder sensor into the chamber by sassing the hole.
(Fig. 4)
11. Remove the sensor support and position the recorder sensor
and then replace the stopper. (Fig. 4)
12. Seal around the hole for recorder sensor completely by
applying the sealing compound (RTV) to outside and inside of
the chamber. (Fig. 4)
13. Connect the power cord of the recorder to the terminal as
shown in Fig. 6.
1
Neutral
2
Live
3
Earth
14. Fix the grille with a screw and replace the side cover.
29
56
Fig. 4
Fig. 5
Fig. 6
Hide quick links:
Advertisement
Table of Contents
