Sanyo MDF-594C Instruction Manual page 28

Ultra-low temperature freezer
Hide thumbs Also See for MDF-594C:
Table of Contents

Advertisement

TEMPERATURE RECORDER (Option)
Setting of back-up temperature
1. There is a red guide on the top of the temperature displayer. Adjust the guide with your finger to
back-up temperature, at which temperature the auxiliary cooling system starts to operate.
2. Set at a temperature 15
Penholder
Install a recording pen in the recording hand as
shown in the figure.
completely inserted for accurate recording.
pen is packed together with the chart.
1. Let down the lever of the penholder, then pull out
the cartridge from the mounted position.
2. Insert a new pen.
3. Mount the cartridge into place.
4. Lift up the penholder lever and make sure that the
pen point touches the chart.
Note:
Turn off the back-up switch when the freezer operation is stopped or the back-up system is not used.
The battery for back-up system is discharged when the back-up switch is kept on.
The additional felt pen or recording paper is available from Sanyo sales agency.
To stop the temperature recorder, remove the cell from the recorder. The back-up system can operate
without recorder cell. Always remove a felt pen as well because the recording paper can be torn
resulting from ink spot. The torn paper may interfere pen tip movement, which results in no activation of
back-up system.
The cell for recorder normally keeps about 1 year. However, the cell life is shorten depending on the
ambient temperature condition. The enclosed cell may have shorter life since it is for monitor.
The liquid leakage or rust can be caused when a used cell or a cell over effective limit is left as it is,
which gives adverse effect on the recorder.
Operate the freezer until the chamber temperature gets to the set temperature. Check the recorded
temperature and chamber temperature displayed on the control panel.
volume on the temperature recorder so that the recorded temperature can corresponds with the displayed
temperature if they are not compliance each other.
27
o
C higher than that of the freezer compartment.
Make sure that the pen is
The
54
Adjust the zero adjustment

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents