Kenmore 790.4710 Use & Care Manual page 25

General Care & Cleaning
Do not use cleaners
on a heated surface. Fumes could be
hazardous. Wait for area to cool
before cleaning. Do not use cleaner
cream to clean porcelain, paint or
aluminum because it can damage the
surface.
Do not use the following on the ceramic glass cooktop:
o Do not use abrasive cleaners and scouring pads, such as metal and
some nylon pads, They may scratch the cooktop, making it more
difficult to clean,
Do not use harsh cleaners, such as chlorine bleach, ammonia or oven
cleaners, as they may etch or discolor the cooktop,
Do not use dirty sponges, cloths or paper towels, as they can leave soil
or lint on the cooktop which can burn and cause discoloration,
Special Caution for Aluminum Foil and Aluminum Cooking
Utensils
Aluminum foil
Use of aluminum foil will damage the cooktop. Do not use under any circum-
stances.
Aluminum utensils
Since the melting point of aluminum is much lower than that of other metals,
care must be taken when aluminum pots or pans are used. If allowed to boil
dry, not only will the utensil be ruined, but it may fuse to, break or mark the
ceramic glass surface, permanetly damaging it.
Care and Cleaning of Stainless Steel (Stainless Steel models only)
Some models are equipped with stainless steel exterior parts. Special care and cleaning are
required for maintaining the appearance of stainless parts. Please refer to the table
provided at the beginning of the General Care & Cleaning section in this Use & Care
Guide.
Lock engaged
for door removal
Figure I
HINGESLOT
Door removed from the
range
Figure 2
Removing and Replacing the Oven Door
The door is heavy. For safe, temporary storage, lay the door flat with the
inside of the door facing down.
To Remove Oven Door:
1. Open the door to the fully opened position.
2. Pull up the lock located on both hinge supports and engage it in the hinge levers (Figure
1). You may have to apply a little downward pressure on the door to pull the locks fully
over the hooks.
3. Grab the door by the sides, pull the bottom of the door up and toward you to disengage
the hinge supports. Keep pulling the bottom of the door toward you while rotating the
top of the door toward the range to completely disengage the hinge levers (Figure 2).
4. To clean oven door, follow the instructions provided in the General Care & Cleaning
table.
To Replace Oven Door:
1. Grab the door by the sides; place the hinge supports in the hinge slots. Open the door to
the fully opened position.
2. Disengage the lock from the hinge levers on both sides (Figure 3).
Note: Make sure the hinge supports are fully engaged before unlocking the hinge
levers.
3. Close the oven door.
Lock in normal
position
Figure 3
25