Bosch D9000 Series Owner's Manual Supplement page 18

D9000,G & GV2 Series | Owner's Manual Supplement
appears. Enter the new passcode followed by [ENT]. ENTER
AGAIN appears. Enter the new passcode a second time for
confirmation. Press [ENT]. The display shows PASSCODE ADDED
(or PASSCODE CHANGED if the user number was already in the
system).
The system does not accept a passcode that is within two
digits of an existing passcode. This is to avoid conflicts with
duress passcodes. For example, if passcode 123 is already
programmed in the system, the system does not accept 121,
122, 124, or 125 as passcodes.
Systems With Access Control...
ADD LEVEL? (CHANGE LEVEL? If the user number already
7.
exists) appears. Press [ENT].
VALID AREA 1? appears. If you wish this user number to be
8.
valid in Area 1, press [ENT]. If not, press [NEXT].
9. AUTH LEVEL appears. Assign the authority level you wish the
user number to have for this area and press [ENT]. Record this
information.
10. VALID AREA 2? appears. Enter the information necessary for
the areas in the scope of the keypad by following steps 8 and 9 for
each area (up to 8 areas). LEVEL ADDED (or LEVEL CHANGED)
appears when all area assignments are made. Press [ENT].
18
If your system includes access control features, such
as card readers at doors, the following prompt
appears: ADD CARD? (CHANGE CARD? appears for
users who already have cards.)
If the user has card or token access to the building or
area, press [ENT]. PRESENT CARD appears. Present
the card at the card reader and wait for the tone. If the
card or token is read correctly, a tone sounds and the
command center keypad shows CARD ADDED (or
CARD CHANGED if the user already has a card or
token). Press [ENT].
Bosch Security Systems | 5/05 | 33267F