Table of Contents
Advertisement
Plena Easy Line Mixer | Installation and User Instructions | Description
An LED meter monitors the master output before the
zone selection. This signal is also present on the
headphone connector below the output meter.
The Plena Easy Line Mixer has an input for 24 VDC
backup power, but has no built in 24 VDC battery
charger. However, Power Amplifiers from the Plena
product range have a built in 24 VDC battery charger.
A separate battery charger is, therefore, not required.
The charger charges the battery with a 0.5 A constant
current until the battery voltage reaches 27.4 VDC. The
charger then switches over to constant voltage charging
(also known as float charging).
figure 2. 1 : Schematic overview of the Plena Easy Line Mixer
Bosch Security Systems | 2008-03 | PLE-10M2-EU en
Note
When using the unit with backup power of 24 V,
make sure that the unit is always powered ON.
When the unit is switched OFF, the batteries will
be drained as this will be regarded as a power
source. Consequently the unit will revert to 24
VDC power from the 24 V input.
en | 10
Advertisement
Table of Contents
