Drying Procedures - Frigidaire Stackable Dryer Owner's Manual

Drying Procedures
Follow fabric care label instructions
Place small items in a mesh bag
Fill dryer drum t/3 to t/2 full
o Follow the guidelines below for preparing the load for drying,
o Read the Operating Instructions card for operating your specific model
• Always read and follow fabric care labels and laundry product labels°
To reduce the risk of fire, electrical shock, or injury to persons, read
Important Safety instructions, pages 2-3, before operating this dryer
1,
Prepare items for drying.
, Dry items of similar fabric, weight and construction in the same load
• Separate dark items from light-colored items Separate items that shed lint
from those that attract lint If an item sheds lint, turn it inside out,
• Be sure buckles, buttons and trim are heatproof and won't damage the
drum finish Close zippers, fasten hooks and Velcro®-Iike fasteners. Tie
strings and sashesto prevent snagging and tangling
° If possible, turn pockets inside out for even drying
• Check for stains which may not have been removed in washing Dryer heat
may permanently set some stains Repeat stain removal process before
drying
o Placesmall items in a mesh bag to prevent tangling and for easy removal
2. Check that lint screen is clean and in place.
3,
Load the dryer.
o The average load will fill the drum t/3 to 1/2 full Items need room to tumble
freely for even drying and less wrinkling Do not overload dryer
o When drying large items, dryonly2or3atatime Fillouttheloadwithsmall
and medium sized items
o Fordelicate or very small loads, add 2 lint-free towels for better drying, less
wrinkling, and to prevent grease stains caused by fabric softener sheets
• Do not overdry items. Overdrying can causewrinkling, shrinkage, harshness,
and a build-up of static electricity, which can produce more lint
o If desired, add a dryer fabric softener sheet
4. Close the dryer door and set dryer controls (some models).
see operating Instructions card for your specific model controls
5. Turn cycle selector clockwise to the desired setting.
6_
Start the dryer.
• Turn the STARTknob clockwise to ON Hold for 1-2 seconds and release
• To add or remove itemswhen the dryer is running, open the door The dryer
will always stop when the door is opened Allow the drum to come to a
complete stop before reaching inside
• To restart dryer, close the door then turn the STARTknob clockwise to ON
Hold for !-2 seconds and release
When the cycle ends, remove items immediately and hang
or
fold.
tf load is removed before the cycle ends, turn cycle selector to OFF