Important Safety Instructions; Use & Care Guide; Drying Procedures - Frigidaire FCGD2000LS0 Use And Care Manual

Important Safety Instructions Con 't
• ALWAYS disconnect the dryer from the electrical supply before attempting any service or cleaning. Failure to do so can result
in electrical shock or injury.
Do not use any type spray cleanser when cleaning dryer interior. Hazardous fumes or electrical shock could occur.
To prevent injury, do not reach into the dryer if the drum is moving. Wait until the dryer has stopped completely before reaching
into the drum.
To prevent injury and damage to the dryer:
- A#repairs andservicing mustbe performedbyan autherizedservicer unless specifically recommended in this Owner's
Guide. Use only authorized factory parts.
- De nettamper with controls.
- De net install or store the dryer where it will be exposed to the weather.
A thermal limiter switch automatically turns off the motor in the unlikely event of an overheated situation (electric dryers only).
A service technician must replace the thermal limiter switch after correcting the fault.
Failure to comply with these warnings could result in serious personal injuries.
SAVE THESE INSTRUCTIONS
USE AND CARE GUIDE
Drying Procedures
Follow fabric care label instructions.
Place small items in a mesh bag.
Fill dryer drum 1/3 to 1/2 full.
Follow the guidelines below for preparing the load for drying.
Read the Operating Instructions for operating your specific model.
Always read and fellow fabric care labels and laundry preduct labels.
To reduce the risk of fire, electrical shock, or injury to persons, read
important Safety instructions before operating th is dryer.
1, Prepare items for drying.
Dry items of similar fabric, weight and construction in the same load.
Separate dark items from light-colored items. Separate items that shed lint
from those that attract lint. If an item sheds lint, turn it inside out.
Be sure buckles, buttons and trim are heatproof and won't damage the drum
finish. Close zippers, fasten hooks and Velcro@-Iike fasteners. Tie strings and
sashesto prevent snagging and tangling.
If possible, turn pockets inside out for even drying.
Check for stains which may not have been removed in washing. Dryer heat
may permanently set some stains. Repeat stain removal process before
drying.
Place small items in a mesh bag to prevent tangling and for easy removal.
2. Check that lint screen is dean and in place.
3. Load the dryer.
• The average load will fill the drum 1/3 to 1/2 full. Items need room to tumble
freely for even drying and lesswrinkling. De net overload dryer.
When drying large items, dry only 2 or 3 at a time. Fillout the load with small
and medium sized items.
For delicate or very small loads, add 2 lint-free towels for better drying, less
wrinkling, and to prevent grease stains caused by fabric softener sheets.
Do not overdry items. Overdrying can cause wrinkling, shrinkage, harshness,
and a build-up of static electricity, which can produce more lint.
If desired, add a dryer fabric softener sheet.
4. Close the dryer deer and select the cyde, temperature, dryness level and
options desired, See Operating Instructions for your specific model
information.
5. Press START te begin the cyde.
To add or remove items when the dryer is running open the door. The dryer
will stopwhen the door is opened. Allow the d rum to come to a complete stop
before reaching inside.
Close the door and press Start to resume the cycle.
6. When the cycle ends, remove items immediately and hang or fold.
4