Advertisement
Drying Procedures
Follow fabriccare
label instructions,
Place small items in a mesh bag.
J
J
J
J
Fill dryer drum
1/3 to 1/2 full.
Follow the guidelines below for preparing the load for drying.
Read the Operating
Instructions
card for operating your specific model.
• Always
read and follow
fabric care labels and laundry product labels,
_To
reduce the risk of fire, electrical shock, or injury to persons, read
lmportantSafetylnstructions,
pages 2-3, before operating this dryer.
3.
Prepare items for drying.
•
Dry items of similar fabric, weight and construction in tile same load.
Separate dark items from light<olored items. Separate items that shed lint
from those that attract lint. If an item sheds lint, turn it inside out.
Be sure buckles, buttonsand trim are heatproof andwon't damagethe drum
finish. Close zippers, fasten hooks and Velcro@qike fasteners. Tie strings and
sashesto prevent snagging and tangling.
If possible, turn pockets inside out for even drying.
Check for stains which may not have been removed in washing. Dryer heat
may permanently set some stains. Repeat stain removal process before
drying.
Place small items in a mesh bag to prevent tangling and for easy removal.
2.
Check that lint screen is clean and in place.
.
Load the dryer.
The average load will fillthe drum I/3 to 1/2 full. Items need room totumble
freely for even drying and less wrinkling. Do not overload dryer.
When drying large items, dry only2 or 3 at a time. Fillout the load with small
and medium sized items.
For delicate or very small loads, add 2 lint-free towels for better drying, less
wrinkling, and to prevent grease stains caused by fabric softener sheets.
Do not overdry items. Overdrying can cause wrinkling, shrinkage, harshness,
and a build-up of static electricity, which can produce more lint.
If desired, add a dryer fabric softener sheet.
4.
Close the dryer
door and set dryer controls
(some models).
See Operating
Instructions
card for your specific model controls.
5.
Turn cycle selector
clockwise
to the desired setting.
6. Start the dryer.
•
Push Start button for 2 seconds.
To add or remove items when the dryer isrunning, open the door. The dryer
will always stop when the door is opened. Allow the drum to come to a
complete stop before reaching inside.
To restart dryer, close the door, then push the STARTbutton for 2 seconds.
.
•
The dryer will not start if tile cycle selector is in tile OFF position.
When the cycle ends, remove
items immediately
and hang
Of fold,
If load is removed before the cycle ends, turn cycle selector to OFF.
Advertisement
