Frigidaire Stackable Dryer Owner's Manual page 5

Table of Contents

Advertisement

Available languages

Available languages

Features
Cycle Signal Control
(some models)
When the Cycle Signal Control
is ON, a signal will sound at the end of each cycle
and during
the Press Saver setting
(some models)
The volume
is adjustable
on
some models
Drum
Light
(some models)
A drum light will come on whenever the door is opened to illuminate the dryer'
drum during loading and unloading Closing the door turns off the light,
Place the front bar under
the lip of the lint screen opening
Reversible
Dryer
Door
Your dryer is equipped with a reversible door The door can be hinged on the right
or left side Refer to the INSTALLATION INSTRUCTIONS for directions on changing
the door
Drying
Rack (some
models)
use the drying rack to dry items which should not be tumble dried,
t
Open the dryer door and remove the lint screen_
2
Insert drying rack into the dryer drum Placethe front bar under the lip of the
lint screen opening
3
Place items to be dried on top of the rack Weight should not exceed 10 Ibs
Leavespace between items, but do not let items hang over the sides or through
the grids Do not tumble other items when using the drying rack
4
Select a timed dry setting best suited for items being dried Use only the Air Fluff
(no heat) temperature setting for items containing plastic, foam rubber,
rubber-like materials, feathers or down
5
When items are dry, remove the rack and replace the lint screen If lint screen
is not in place, tumbling items could enter the exhaust system and cause
damage to the dryer
Common
Drying
Problems
lvlany drying problems
involve poor cleaning results, poor soil and stain removal, residues of lint and scum, and fabric damage
For satisfactory
drying results, follow
these suggestions
provided
by The Soap and Detergent
Association,
PROBLEM
Greasy, oily
stains
Lint
Pilling
(Fibers break
off, ball up and
cling to fabric )
Shrinking
Wrinkling
POSSIBLE
CAUSES
SOLUTIONS
PREVENTIVE
MEASURES
• Fabric softener sheet
° Rub fabric softener stains with bar soap
o Add a few bath towels to small loads for
Rinse and rewash
proper tumbling
• Some "silk-like" fabrics should be air dried
o Use proper drying temperature
o Place fabric softener sheet on top of load
before starting the dryer,
• Overloading
° Overdrying causes static
electricity
° Lint screen not clean
when cycle began
• Lint is attached to "pills"
• Reduce load size and rewash using liquid
fabric softener in the final rinse
, Or, add a fabric softener sheet and
tumble without heat
• Use lint brush or roller to remove lint
° Do not overload dryer
° Use fabric softener in washer or dryer to
reduce static electricity
o Remove items when they are slightly damp
to avoid overdrying
o Check that lint screen is clean and in place
Pilling is normal with
synthetic and permanent
press fabrics This is due
to abrasion from normal
wear
• Use a lint brush or shaver to remove pills
• Use fabric softener to lubricate fibers,
° When ironing, use spray starch or fabric
finish on collars and cuffs
, Turn items inside out to reduce abrasion
Overdrying
• Overloading
° Leaving items in dryer
after cycle ends
• Irreversible condition
, Reduce load size and tumble at medium.,
or low heat for 5-t0 minutes
° Remove items immediately
Hang or fold
• Follow fabric care label directions
° If shrinking is a concern, check load often
° Remove items while slightly damp and
hang or lay flat to complete drying
o Block knits into shape
° Do not overload dryer
o Remove items as soon as cycle ends

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents