Control Lock - Kenmore 796.8137 Series Use & Care Manual

CYCLE OPTIONS AND SPECIAL FEATURES
Your dryer features several additional cycle options and special features to meet your individual needs. For all steam
features, see the following pages.
WRINKLE GUARD
-- DampDrySignal 1 Selecting this option will tumble the
Vh_nkle O _o_d J clothes after the cycle ends for a few
seconds every few minutes without
heat. This option is active for 150
minutes after the end of the cycle, or until the door is
opened. This helps prevent wrinkles if the clothes are not
removed immediately after the cycle has finished.
To activate Wrinkle Guard, press and hold the DAMP
DRY SIGNAL button for approximately three seconds.
CONTROL LOCK
J ] Usethisoptiontodisabtethecontrots.
@ Touch Up The Control Lock can only be
Control Lock I_
activated during a cycle. When the
controls are locked "CL" will display
alternately with the estimated time remaining. If
Wrinkle Guard is not activated when the controls are
locked, the LED will blink. Once set, the Control Lock
must be turned off before the controls can be used.
Press and hold the TOUCH UP button for five seconds to
lock or unlock the controls.
MY CYCLE
j My Cycle allows you to store a
My Cycle customized dry cycle for future use. It
allows you to save favorite temperature,
dry level, and other options for a cycle, and then recall them
at the touch of a button.
NOTE: Only one My Cycle can be saved at a time. Press
and hold the MY CYCLE button to overwrite any previ-
ously saved cycle.
To save a MY CYCLE:
Pressthe POWER Button to turn on the
dryer.
Turn the
cycle
selector knob to select the desired
cycle.
O Press the CYCLEMODIFIERButton to change the desired setting.
O Pressthe CYCLE OPTION Button to add the desired options.
O Pressand hold the MY CYCLE Button.
DAMP DRY SIGNAL
Damp Dry SignaU ! if you press the Damp Dry Signal, the
W'r_ok_e Guard J dryer will emit a chime when the
clothes are just short of completely
dry, in case you want to remove them for ironing or
hang drying.
iNSTALLiNG AND USING THE DRYING RACK
O
With the dryer door open, slide the rack into the
dryer drum.
Make sure the front of the rack is seated properly in
the recess on the tint filter housing at the front of the
drum. The two rear legs of the rack should be resting
on the rear wall just above the drum.
Place items to be dried on the rack. Make sure that
no parts of the items hang over the edges of the
rack, as they might be contacted by the rotating
drum, causing noise or damage to the drum
or items.
NOTE: Be sure to remove the drying rack after using
the Rack Dry cycle.
To recall a MY CYCLE:
O Press the POWER button to turn on the dryer.
O ressthe MY CYCLE button. The stored settings will
be displayed.
O Press the START/PAUSE button to start the cycle.
NOTE: My Cycle can be adjusted the same as any
other cycle. However, once any other button is pressed,
the LED will turn off, indicating that the settings are no
longer those of your saved cycle.
25