Cycle Options And Special Features; Wrinkle Guard; Control Lock; My Cycle - Kenmore 796. 8147 Use & Care Manual

CYCLE OPTIONS AND SPECIAL FEATURES

Your dryer features several additional cycle options and special features to meet your individual needs. For all steam
features, see the following pages.
WRINKLE GUARD
Selecting this option will tumble the
clothes after the cycle ends for a few
seconds every few minutes without heat.
This option is active for 150 minutes after
the end of the cycle, or until the door is
opened. This helps prevent wrinkles if the clothes are not
removed immediately after the cycle has finished.
CONTROL LOCK
Use this option to disable the controls. The
Control Lock can only be activated during
a cycle. All controls will be disabled.
Once set, the CONTROL LOCK must be
turned off before the controls can be
used. After the dryer has shut off, the POWER button
will allow the dryer to be turned on, but the controls will
remain locked. When the controls are locked "CL" will
display alternately with the estimated time remaining. If
Wrinkle Guard is not activated when the controls are
locked, the LED will blink. Press and hold the WRINKLE
GUARD button for five seconds to lock or unlock the
controls.
MY CYCLE
MY CYCLE allows you to store a customized
dry cycle for future use. It allows you to save
favorite temperature, dry level, and other
options for a cycle, and then recall
them at the touch of a button.
NOTE: You can only save the customized settings for one
cycle at a time. Pressing and holding the MY CYCLE
button will overwrite any previously saved cycle.
To save a MY CYCLE:
1
Press the POWER button to turn on the dryer.
2
Turn the cycle selector knob to select the desired cycle.
Press the CYCLE MODIFIER button to change the desired setting.
3
4
Press the CYCLE OPTION button to add the desired options.
5 Press and hold the MY CYCLE button.
To recall a MY CYCLE:
1
Press the POWER button to turn on the dryer.
2 Press the MY CYCLE button. The stored settings will
be displayed.
3
Press the START/PAUSE button to start the cycle.
NOTE: MY CYCLE can be adjusted the same as any
other cycle. However, once any other button is pressed,
the LED will turn off, indicating that the settings are no
longer those of your saved cycle.
DAMP DRY SIGNAL
If you press the Damp Dry Signal, the
dryer will emit a chime when the clothes
are just short of completely dry, in case
you want to remove them for ironing or
hang drying.
DRUM LIGHT
Use the DRUM LIGHT button to turn on
the light inside the drum during
cycle operation.
NOTE: The drum light will also come on if the dryer
door is opened; however, after the dryer has been
off for more than four minutes, the drum light will be
disabled until the POWER button is pressed to turn on
the dryer.
INSTALLING AND USING THE DRYING RACK
With the dryer door open, slide the rack into the
1
dryer drum.
Make sure the front of the rack is seated properly in
2
the recess on the lint filter housing at the front of the
drum. The two rear legs of the rack should be resting
on the rear wall just above the drum.
Place items to be dried on the rack. Make sure that
3
no parts of the article hang over the edges of the
rack, as they might be contacted by the rotating
drum, causing noise or damage to the drum
or articles.
NOTE: Be sure to remove the drying rack after using
the RACK DRY cycle.
25
HOW TO USE