Removing And Installing Parts; Ddr Memory Overview; Memory Installation Guidelines - Dell Dimension 1100 Service Manual

Back to Contents Page

Removing and Installing Parts

Dell™ Dimension™ 1100/B110 Systems Service Manual
Memory
Cards
Front Panel
Drives
Hard Drive
Floppy Drive
Memory
You can increase your computer memory by installing memory modules on the system board. For information on the type of
memory supported by your computer, see
NOTE:
DDR 333 memory operates at 320 MHz when used with an 800-MHz front-side bus.

DDR Memory Overview

DDR memory modules should be installed in pairs of matched memory size. This means that if you purchased your computer
with 128 MB of memory installed and you want to add another 128 MB of memory, you should install it in the appropriate
connector. If the DDR memory modules are not installed in matched pairs, the computer will continue to operate, but with a
slight reduction in performance.
NOTE:
Always install DDR memory modules in the order indicated on the system board.
NOTE: Your computer has two memory slots labeled DIMM3 and DIMM4.
The recommended memory configurations are:
Install a pair of matched memory modules in connectors DIMM3 and DIMM4.
Do not install ECC memory modules.
If you install a mixed pair PC2700 (DDR 333-MHz) and PC3200 (DDR 400-MHz) memory, the modules function at the
slowest speed installed.
Be sure to install a single memory module in DIMM3 or the connector closest to the processor before you install
modules in the other connector.

Memory Installation Guidelines

CD/DVD Drive
Processor
Fan Assembly
System Board
Power Supply
Battery
Technical Specifications.