2. Locate the 3-pin password jumper (PSWD) on the
the password.
NOTE:
When you receive your computer, the jumper plug is attached to pins 1 and 2.
3. Close the computer cover.
4. Connect your computer and monitor to electrical outlets, and turn them on.
5. After the Microsoft Windows desktop appears on your computer,
6. Turn off the monitor and disconnect it from the electrical outlet.
7. Disconnect the computer power cable from the electrical outlet, and press the power button to ground the system
board.
8. Open the computer cover.
9. Locate the 3-pin password jumper on the
password feature.
10.
Replace the computer
NOTICE:
To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.
Connect your computer and devices to electrical outlets, and turn them on.
Back to Contents Page
system board
cover.
system board
and attach the jumper plug to pins 2 and 3 to clear
shut down the
and attach the jumper to pins 1 and 2 to re- enable the
computer.