Dell Dimension 1100 Service Manual page 19

program is incorrect or the
CMOS
battery charge may be low.
Checksum
Failure
CMOS System
Options Not
Set
CMOS Display
Type
Mismatch
CMOS Memory
Size
Mismatch
CMOS Time
and Date Not
Set
Drive A or B is present but has
Diskette
Boot Failure
failed the BIOS POST.
Error in the DMA controller on
DMA Error
the system board.
DMA 1 Error
DMA 2 Error
The BIOS cannot communicate
FDD
Controller
with the floppy drive or hard
Failure
drive controller.
HDD
Controller
Failure
An interrupt channel on the
INTR1 Error
system board failed to POST.
INTR2 Error
The operating system cannot be
Invalid Boot
Diskette
located on drive A or drive C.
The BIOS has detected a stuck
Keyboard
Error
key.
An error occurred with the
KB/Interface
Error
keyboard connector.
The operating system cannot be
No ROM
Basic
located on drive A or drive C.
Back to Contents Page
computer.
Ensure that the drive is installed correctly in
the computer and defined correctly in the
system setup program. Check the interface
cable at both ends.
The keyboard or system board
be replaced.
Ensure that the drive is installed correctly in
the computer and defined correctly in the
system setup program. Check the interface
cable at both ends.
The keyboard or system board
be replaced.
Enter the system setup program
that drive A or drive C is properly identified.
Ensure that nothing is resting on the
keyboard; if a key appears to be stuck,
carefully pry it up. If the problem persists,
you may need to replace the keyboard.
Ensure that nothing is resting on the
keyboard; if a key appears to be stuck,
carefully pry it up. If the problem persists,
you may need to replace the keyboard.
Enter the system setup program
that drive A or drive C is properly identified.
may need to
may need to
and confirm
and confirm