Dell Latitude CPi A Service Manual page 43

36 Dell Latitude CPi A Service Manual
4. Remove the two 3.5-mm screws securing the TCA to the microprocessor
module.
5. Remove the TCA from the microprocessor module.
6. If a processor hold-down clip is attached to the processor module fence,
remove the clip.
Your computer may have a one- or two-slot hold-down clip. One tab locks the
one-slot hold-down clip to the fence. Two tabs lock the two-slot clip to the
fence. To remove the clip, perform the following steps to bend the tabs away
from the fence:
a. Insert a small flat-blade screwdriver into one of the slots at the top of the
clip (see Figure 27).
b. Bend the tab away from the fence by carefully tipping the screwdriver
away from the processor module.
c. If your computer has a two-slot hold-down clip (see Figure 27), repeat
substeps a and b for the second slot .
d. Lift the clip off the fence and discard it.