Led In Di Ca Tor; Ig Ni Tion In Put; Chan Nel 2 Ac Ces Sory Out Put; Park Ing Light Out Put - Avital Tornado 2 Installation Manual

LED In di ca tor

1. Discuss placement with the owner.
2. Choose a location that is visible from both sides of the vehicle.
3. Drill a ¼" hole.
4. Route the LED wires through the hole and press LED into place.
5. Route the LED wires to the control unit.
6. Plug the RED LED connector into the control unit RED plug.

Ig ni tion In put

1. Use a voltmeter to locate the one wire that shows +12 volts when the
ignition key is in the "ON," "CRANK" and "RUN" position, and 0 volts
when the ignition key is in the "OFF" position.
2. Connect the control unit PINK wire to the vehicle's ignition wire.

Chan nel 2 Ac ces sory Out put

The DARK BLUE wire provides a 0.75 second ground (-) output when the
remote control button #2 is activated for 1-2 seconds. If the remote control
button #2 is continuously pressed, the signal will stay at ground as long as the
button is held. Most trunk releases are positive and require an optional relay.
Park ing Lights
1. If the parking lights are positive trigger, connect the RED/WHITE wire
to the battery positive (+) terminal through the 20 amp fuse.
NOTE: Do not connect the RED/WHITE wire to the control unit RED
wire.
2. If the parking lights are negative (-) trigger, connect the RED/WHITE
wire to control unit BLACK wire.
3. Connect the RED/BLACK wire to the vehicle parking light wire.

In te rior Light Trig ger

7
2
Tornado Installation Manual 1/5/98