Programming Your Re Mote Con Trols; Pro Gram Ming Ta Ble For Re Mote Con Trols - Avital Tornado 2 Installation Manual

Programming Your Re mote Con trols

2
The Tornado allows you to add new remote controls in one step, delete lost
or stolen remote controls or rearrange the factory preset remote control
functions.
All remote control programming features are accomplished by turning the
ignition key on (or starting the vehicle) and flicking the valet switch on and
off a preset number of times.
1. Remove the alarm from valet. Programming cannot be accessed while
the alarm is in the valet mode, indicated by the alarm LED on solid red.
2. Select the feature from the "Programming Table for Remote Controls."
Note the number of chirps.
3. Turn the ignition key to the "ON" position.
4. Within 10 seconds, begin flicking the valet switch on and off. The siren
will chirp one time each time you flick the switch on then off.
5. Continue flicking the valet switch on and off until you reach the
number of chirps associated with your chosen feature.
NOTE: Stop on the chirp.
6. Follow the "Secondary Action."
7. Turn the ignition key off.
8. Repeat steps 1-7 for any other feature you wish to program.

Pro gram ming Ta ble for Re mote Con trols

Fac tory
Fea ture
Set ting
Arm/Disarm/Remote
Channel 1
Panic
Accessory (-) Output Channel 2
Silent Arm/Disarm Channel 3
All Channel Learn —
Instant Code
—
Deletion
# of
Chirps
Press any remote control button you choose to operate
8
this feature. Siren will chirp once for confirmation.
Press any remote control button you choose to operate
9
this feature. Siren will chirp twice for confirmation.
Press any remote control button you choose to operate
10
this feature. Siren will chirp 3 times for confirmation.
Press button #1. The siren will chirp 1 time. Remote
11
control will operate at factory preset order.
Wait 3 seconds. The siren will chirp twice. All remote
12
controls are erased from memory.
14
2
Tornado Installation Manual 1/5/98
Sec on dary Ac tion