Autostart AS-6320 FM Installation Manual page 7

This input should be used in vehicles that use a negative-switching
Dome Light circuit. Connect to a Dome Light wire testing ground with a
Door open.
CAUTION! You can only use a negative or a positive connection. In
GRAY
11 (–) Negative other words, only the NEGATIVE DOOR INPUT or the POSITIVE
Door input
DOOR INPUT wire is connected. It is essential that the Module be
connected in such a way as to allow each one of the Doors to turn off
Ready Mode: the driver-side Door Pin does not constitute by itself a
sufficient connection.
This positive input will monitor the Glow Plug Light in Diesel Mode: it will
wait until the Glow Plug Light goes out to crank the Engine. Connect to
the side of the Glow Plug Light that is positive when the Light is on.
Note: In Diesel Mode there is a 18-sec. crank timing delay (or
approximately 25-sec. if the run time is set to 30 min.): if the Glow Plug
Light is still on after the delay expires, the Module will proceed to start
the Engine.
(Also known as the "wait-to-start light".) The purpose of the Glow-plug
circuit on diesel vehicles is to pre-heat the Combustion Chamber before
the vehicle is started.
When a Remote Starter is installed on a diesel vehicle, the Glow- plug
section of the Ignition circuit must be activated and allowed to operate
before the vehicle is remote-started. For that purpose, the Glow-plug
input wire of the Module must be connected to the Glow-plug indicator
light of the vehicle. The Module will only accept positive Glow-plug input
signals, if the signal is negative, use a relay to invert its polarity. A diode
must be added between the negative Glow-plug trigger on the relay and
the negative Glow-plug wire of the car. This is to prevent feedback
effects on the Glow-plug indicator light on the instrument cluster: the
light on the dash would come on because of the feedback, even though
YELLOW
the circuit is off.
(+) Glow-
12
When the user remote-starts the vehicle:
plug Light
input The Module will power up the Ignition circuit and wait to engage the
Starter Motor while the Glow-plug indicator light is still on.
The Module will engage the Starter Motor as soon as the Glow-plug
light (+) goes out.
Minimum waiting time is 3 seconds.
Maximum waiting time is 25 seconds (approx.).
If no Glow-plug wire is found on the vehicle, the Glow-plug input on the
Module may be "timed out". The Module will power up the Ignition and
Glow-plug circuits and simply wait for the time-out before starting:
Connecting the Glow-plug input wire of the Module to Ignition will
hold the ignition
25 sec. (recommended).
Keeping the Glow-plug input wire of the Module unconnected will
hold the ignition
recommended in very cold environments).
Connect the Glow-plug wire to the Ignition wire only after Tach has been
programmed (i.e.: Connecting the Glow-plug wire is one of the very last
steps in the installation process).
Installation Guide
for the maximum waiting time of approximately
ON
for the minimum waiting time (3 sec., not
ON
P.7