Table of Contents
Advertisement
Memory Tests
Exiting Test
Mode
A
Display Message
VOICE ALL GOOD
ERROR CODE (06)
All Other Codes
4
Pressing 4 on the numeric keypad starts an
automatic sequence of tests, performing memory
and line tests in order.
The first of these tests writes to and reads from all
RAM locations. If any error is detected, the test
sequence stops at that point and reports by
displaying an error code on the display; for example,
SELF TEST (MEMORY/LINE TEST)
ERROR CODE (06)
(06) is only one example. Other codes may appear
in its place if different errors are discovered.
Any error code display reflects an error condition
to be handled by your System Administrator.
No other test requests are allowed during this test.
If any error is detected, the test sequence stops at
that point and reports by displaying an error code.
If all tests terminate successfully, the following
display shows on the LCD:
SELF TEST (MEMORY/LINE)
VOICE ALL GOOD
To exit test mode, remove power and reapply it.
Table B-1 Self-Test Result Codes
Test Result
Normal
Line, NT , or terminal
is not operational
Terminal is not
operational
APPENDIX A
Action
1) Check ISDN line
connection.
2) Call Fujitsu
Technical Assistance
Call Fujitsu
Technical Assistance
Advertisement
Table of Contents
