Call Appearance Preference - Fujitsu SRS-9924-ABM User Manual

Ni and 5e custom
Table of Contents

Advertisement

CALL
APPEARANCE
PREFERENCE
*
5.
Repeat steps 2, 3, and 4 as needed until this screen
appears:
INTERCOM FEATURE (1)
(ONE OR TWO WAY)
NEXT
6.
INTERCOM FEATURE (2)
NON SUPPORTED
Note the number (2) on the first line indicating you
are about to program your second call screener
number. Pressing NEXT repeatedly at this prompt
will cycle you through all three call screener
selections to the one you want to program or
change.
The preference options determine which CA
button is selected when you go offhook (lift the
receiver or press SPKR). You have four choices.
Primary line preference. Selects button
number 1, the CA associated with your primary
DN.
If you have an incoming call on button number
1, you are immediately connected to the call.
If button number 1 is idle, you get a dial tone.
If you are going offhook to retrieve a call on
hold on button number 1, you must press the
button to reconnect to the call.
To be connected to an incoming call on
another button, or to get a dial tone on an
idle button, press the button either before or
after you go offhook.
No preference. Does not automatically select
any CA button when you go offhook. You must
press the button you wish to be connected to
either before or after you go offhook.
10
ENTER
919*926*3112
3-23
3

Advertisement

Table of Contents
loading

This manual is also suitable for:

Srs-9924Srs-9912

Table of Contents