Acura 2010 TL Owner's Manual page 532

3. Pull the taillight assembly straight
back out of the body.
BULB SOCKET
4. Determine which of the three
bulbs is burned out: back-up light,
turn signal, or side marker.
5. Remove the socket by turning it
one-quarter turn counterclockwise,
and pull the bulb straight out of its
socket.
2010 TL
6. Push a new bulb straight into the
socket until it bottoms, and
reinstall the socket into the light
assembly by turning it clockwise
until it locks.
7. Turn on the lights to make sure
the new bulb is working.
8. Reinstall the trunk lining. Make
sure it is installed under the edge
of the trunk seal.
9. Put the holding clip into the hole
on the side of the trunk lining.
Reinstall the screw.
Lights
529