Insert Srmemory Card - Sony SRMASTER SR-R4 Operation Manual

• The voltage shown is the actual voltage used by the
unit (this may be lower than the input voltage and the
F65 DC IN connector).
When a battery pack is selected
The battery symbol is shown.
16.5V
• When fully charged, all seven segments are lit.
As the battery pack discharges, the segments go
out from left to right.
• When the battery pack is almost exhausted
(NEAR END), the voltage indication and the
tally indicator start to flash, and an intermittent
warning tone sounds in the earphones.
• When the battery pack is completely exhausted
(END), the corresponding warning indication
lights, the tally indicator starts to flash at a
higher rate, and the earphones warning tone
sounds continuously.
Tip
The DCIN TYPE option in the SYSTEM Setup menu
allows you to set the battery voltages which trigger the
NEAR END and END warnings. (see page 46)
When AC power is selected
The connector symbol is shown.
16.5V
22

Insert SRMemory Card

Insert SRMemory Card
Supported SRMemory cards
The unit supports the following SRMemory
cards.
59.94p
SRMemory card
SR-256S55
SR-512S55
23.97p
SRMemory card
SR-256S55
SR-512S55
1) The recording time varies depending on the model
and recording conditions.
To insert the SRMemory card
1
Press the lid open/close button to open
the lid of the SRMemory card slot and
insert the SRMemory card.
Take care to insert the SRMemory card with
the correct orientation.
Tip
If the LID LOCK indicator is lit in orange, showing
that the lid is locked, press the EJECT button on the
control panel to unmount the card first, and then
open the lid.
1)
Recording time
(F65RAW mode)
6
12
Unit: Minutes (approx.)
1)
Recording time
(F65RAW mode)
15
30
Unit: Minutes (approx.)
SRMemory card