Additional Function Menu Settings - Sony PDWHR1 Operations & Installation Manual

In the case of an XDS Series device, if the sub-item TS
MODE of the setup menu item 926 is set to "HDV",
metadata other than timecode data is not transmitted.
Additional Function Menu
Settings
When the target device is the PDW-HR1
When this board is installed in the PDW-HR1, the
underlined settings in the following tables appear in the
function menu.
For more information about function menu operations,
refer to Chapter 3 "Preparations" in the PDW-HR1
Operation Manual.
P1 VIDEO page
Item Setting
F1: V INPUT Selects the video input signal.
HDSDI: HDSDI signal
SDSDI: SDSDI signal
CMPST: Composite signal
i.LINK: i.LINK signal
DVB-ASI: DVB-ASI signal
SG: Test signal from internal signal
generator
Notes
• When "i.LINK" is selected, HDSDI output and SDSDI
output in the PDW-HR1's E-E mode is not guaranteed.
DVB-ASI TS signals are not output in the REC mode or
E-E mode.
• If you select "DVB-ASI", then DVB-ASI TS signals and
i.LINK TS signals are not output, regardless of the
operating mode of the PDW-HR1.
P2 AUDIO page
Item Setting
F1: AU INPUT Selects the audio input signal to assign to
audio channels 1 to 8.
SDI: Audio signal embedded into SDI signal
ANALOG1: Analog 1 audio signal
SG: Test signal from internal signal
generator
i.LINK: i.LINK signal
DVB-ASI: DVB-ASI signal
Sub-item
F1: A1 INPUT (A5
INPUT)
F2: A2 INPUT (A6
INPUT)
F3: A3 INPUT (A7
INPUT)
F4: A4 INPUT (A8
INPUT)
Input signal of audio
channel 1 (5)
Input signal of audio
channel 2 (6)
Input signal of audio
channel 3 (7)
Input signal of audio
channel 4 (8)

Additional Function Menu Settings

13