Options; Operands; Extended Description - Fujitsu SPARC Enterprise M3000 Rci User's Manual

• OPTIONS

The following options are supported:
-c exrdy
RCI_address
[time]
-c opcalldisp
-c opcallon
RCI_address
callNo
-c opcalloff
RCI_address
callNo
-h

• OPERANDS

The following operands are supported:
RCI_address
time
callNo

• EXTENDED DESCRIPTION

When the setrci(8) command or setrcic(8) command is being executed on another
host in the RCI network, do not execute the setrcic(8) command.
When the setrcic(8) command is executed, set all RCI units that are connected to
RCI into the power-on state or standby state.
Executing the setrcic(8) command on a model that does not support the RCI
function causes an error to occur.
C120-E360-06EN
Sets the EXRDY monitoring timeout period of the specified external
power control devices. Set the EXRDY monitoring timeout period in
units of minutes for time. If 0 is specified, EXRDY monitoring is
disabled. If time is omitted, the EXRDY monitoring timeout period is
displayed.
Displays the status of the operator call signals of the specified external
power control devices.
Sets the operator call signals of the specified external power control
devices on. Setting is made for the devices corresponding to the bits of
callNo that contain "1".
Sets the operator call signals of the specified external power control
devices off. Setting is made for the devices corresponding to the bits of
callNo that contain "1".
Displays usage statement. When used with other options or operands, an
error occurs.
Specifies a target RCI address. A value in any of the following ranges
can be specified for RCI_address:
003001ff-00307fff
007001ff-00707fff
Sets the EXRDY monitoring timeout period when "-c exrdy" is specified
in units of minutes. Any decimal integer number ranging from 0 to 85
can be specified.
Specifies operator call information. A two-digit hexadecimal number
can be specified.
3.2 setrcic
3-9