Using Goto Routes; Creating A Goto Route - Magellan MAP330 - MapSend CD For Meridian User Manual

Map330 series

Hide thumbs Also See for MAP330 - MapSend CD For Meridian:

Table of Contents

Basic Operation

A GOTO route is simply a route with a start point and a single destination point;

I am here and I want to go to there. All that is required to create a GOTO route

is having the destination waypoint saved in memory. This waypoint can be one

that you have saved earlier (which is stored in your User Waypoint List) or any of

the landmarks that come with the MAP 330 in its built-in database.

and then you would save that position with a name like "Parked." After

your hike, you can use the GOTO function (described following this

section) and select "Parked" as your destination from the User Waypoint

List. The MAP 330 will then guide you back to your car.

Press GOTO. The first thing that has to be done is to

select the destination waypoint. This is done by

accessing the waypoint database. The first screen is

used to select the category of the database that the

waypoint is in and how it will be found, alphabetically

or nearest to your position or cursor.

Selecting a Destination Waypoint from the Database using "Near Position"

Use the UP/DOWN arrows to highlight the category that your destination

waypoint is in. Use the LEFT/RIGHT arrows to select how the waypoints are

displayed, Alphabetical, Near Position or Near Cursor. In this case, you will be

using "Near Position".

For example, suppose you parked your car and

planned on going hiking for about an hour. And

suppose that when you are done with your hike you

want directions for getting back to your car. It's all

very simple. First, at the location you parked your car

you would use the MAP 330 to compute that position

Magellan MAP 330 GPS Receiver

Table of Contents

Map 330m