Chapter 6 Using The I.link Connector For Dubbing And Tc Insert; Digital Dubbing; Connections And Settings - Sony HVR-1500A Operating Instructions Manual

Using the i.LINK Connector
for Dubbing and TC Insert

Digital Dubbing

In addition to straightforward tape dubbing, you can also
use this unit to dub signals in HDV 1080i or DVCAM/DV
format automatically from the beginning of the tape to the
end through the i.LINK interface.

Connections and settings

The following figure shows an example of the connections
for carrying out dubbing through the i.LINK interface,
using this unit as the recorder, and an HVR-Z1 as the
player.
66
Digital Dubbing
Chapter
HVR-Z1 (player)
(4-pin)
HDV/DV
HVR-1500A (this unit as recorder)
VIDEO
IN Y/S-Y/CPST R-Y/S-C B-Y
REF.VIDEO VIDEO OUT (SUPER)
IN(SD/HD) Y/CPST Pr/R-Y/S-C Pb/B-Y/S-Y CPST
IN(SD/HD) SDI OUT1 OUT2 SDI OUT1 OUT2
HD SDI
1/2
TC IN OUT MONITOR
AUDIO
HDV/DV
(6-pin)
HVR-Z1 (player) setting
1)
VCR HDV/DV in the
(IN/OUT REC) menu: HDV
or DV
1) The i.LINK output format must be set.
For details of the HVR-Z1 settings, refer to the HVR-Z1
Operating Instructions.
6
AC IN
AUDIO
IN
1/3 2/4
AUDIO
OUT
1/3 2/4
IN AUDIO I/O (AES/EBU) OUT
3/4 1/2 3/4
HDV/DV
REMOTE
i.LINK cable (not supplied)
Settings on this unit
Depending on what you want
to input, press the HD VIDEO
button in the video/audio
input selection section to
display i.LINK:HDV in the
input signal display, or press
the SD VIDEO button to
display i.LINK:DV or
i.LINK:DVCAM.