Table of Contents
Advertisement
About the camera control method
You can control the camera from host device such as a
PC. The following table shows the control functions.
You can send a command corresponding to the control
items, with parameters for the desired settings, if
necessary, from the host device to control the camera.
Refer to "Camera Control Command" on page 16 for
details on how to send a command, the commands, and
their parameters.
Control functions
Description
Operating mode
Normal/Trigger
Shutter speed
Normal 1 –
Trigger
Gain
0 to +18 dB
Binning function
OFF/ON
Partial Scan function OFF/ON
Detail
OFF/ON
External trigger input 26-pin connector / DC-700 / 700CE
White balance
Preset/Manual/AWB
(XCL-U1000C only)
Matrix
OFF/ON
(XCL-U1000C only)
Note
Make sure to supply power to the camera module and
confirm that the camera module is operating before
inputting a trigger signal. If you input external signals
to a camera module without the power supplied, this
may cause a malfunction of the camera module.
1
/
10000
1
1
Internal setting:
/
–
/
15
10000
Setting by trigger pulse width
Overview
9
Advertisement
Table of Contents
