Advertisement
CNU-700 Camera Command Network Unit
The CNU-700 allows communication between all the units in the system, and
provides the ability to assign CCUs, MSUs, RCPs, and HDC-2000 Series camera
heads. A RISC-based microprocessor system provides high-speed transfer of
command signals to the HDCU-2000 and HDCU-2500 Camera Control Unit for
rapid response and reliable control.
One CNU-700 unit can control six cameras, and can be expanded to control up to
12 cameras when fitted with an optional BKP-7930 Expansion Board. Several
CNU-700 units can be connected to the camera control network in a large
system. The CNU-700 supports RCP assignment and an S-BUS interface*
*1 An optional BKP-7933 S-BUS Interface Board is required.
CNU-700
HZC-CSM10 Camera System Management Software
The HZC-CSM10 is a Microsoft Windows-based Master Setup Unit (MSU) software
application for controlling the camera system from a PC. It has similar features to
a hardware-based MSU, offering camera control, optical level display, file
management, remote control panel (RCP) assignment, and diagnosis. The
HZC-CSM10 GUI controls any parameters of the system camera and enables
visual setting lists. It acts as a software client to a master hardware MSU.
System requirements
.
1
Operating system: Windows® 7 (with Service Pack 1 installed), Windows 8
Professional:
32-/64-bit, Ultimate: 32-/64-bit
(The software cannot be installed on Windows Vista® and
Windows XP.)
CPU:
1 GHz or faster 32-bit (x86) or 64-bit (x64) processor
Memory:
2 GB or more
Hard disk:
50 MB or more of free space
HZC-CSM10 Camera System Management Software
CCU
Camera Head
MCS Mode: Client
CCU
Camera Head
MCS Mode: Client
CCU
Camera Head
MCS Mode: Client
CNA-1
HZC-CSM10
Software
Network Hub
PC
RCP-1000/1500
Series
: LAN Cable
25
Advertisement
