Appendix E: Troubleshooting, continued
Sound
Symptom
2.
The sound does not match the screen
picture.
3.
The sound from my A/V receiver does
not match the screen picture (I should
hear the correct audio from my A/V
receiver).
4.
Cannot select an audio-only device; it
does not appear in the Activity menu.
5.
Sound is coming from the TV speakers
instead of the A/V receiver.
NetCommand IR Control (NetCommand-equipped models only)
Symptom
1.
Cannot see the menu from the A/V Receiver.
2.
NetCommand unable to learn specific device
keys.
Remarks
The TV's "Listen to:" setting may be set to SAP (analog program from
the ANT input).
•
Check that DIGITAL AUDIO OUTPUT and/or AVR AUDIO
OUTPUT on TV's main panel is connected to the A/V receiver.
Without this connection, devices connected only to the TV (and
not the A/V receiver) can be heard only from the TV speakers.
Note that this includes the ANT input, a device (such as a
camcorder) connected to the convenience panel, and any other
device sending audio to the TV only.
•
If using a NetCommand-controlled A/V receiver, NetCommand
may be selecting the wrong A/V receiver audio input. Check the
A/V receiver's NetCommand setup in the Inputs > AVR menu.
Plug an unused video plug into the Y/VIDEO jack to activate Auto
Input Sensing and make the audio device selectable in the Activity
menu.
Disconnect headphones. Connect the TV's AUDIO OUT to the A/V
receiver and select AV Receiver from the New Device Found screen.
Remarks
•
A/V Receiver Set Up for Audio-Only Switching
The A/V Receiver is not connected to any video input of the
TV. To check the A/V Receiver menu, temporarily plug into
an unused input of the TV, such as Input 3. Exit the New
Device Found screen and select Input 3 from the Activity
menu. Press MENU on the A/V receiver's remote control.
A/V Receiver Set Up for Audio and Video Switching over
•
HDMI
Use the MENU key on the A/V receiver's remote control.
•
A/V Receiver with
Switch the remote control to AUDIO mode. Press the
MORE key and then 1 (Menu).
•
A/V Device does not use IR format for remote control
signal. ITT and RF formats cannot be learned.
•
Room lighting may affect the signal. Have the remotes very
close (6 inches or less) to the TV during Learning.
•
If learning a Mitsubishi remote control, make sure mode is
not set to TV.
•
Some, but not all, device key functions can be learned by
NetCommand. For example, POWER and PLAY may be
learned, but other functions may not.
•
The signal from the remote control may not be strong
enough. Insert fresh batteries and try Learning again.
Appendices
HDMI Control
83