Ir Emitter Placement - Mitsubishi Electric UNISEN LT-40151 Owner's Manual

151/153 series immersive sound lcd hdtv with integrated sound projector
Hide thumbs Also See for UNISEN LT-40151:
Table of Contents

Advertisement

IR Emitter Placement

The NetCommand system uses emitters connected
to the IR–NetCommand Output jack to control other
devices such as DVD players, cable boxes, satellite
receivers, and VCRs.
IR emitter cables are available for purchase from
Mitsubishi. Call (800) 553-7278 and request either part
number 242D483020 (two-ended cable) or part number
299P254020 (four-ended cable).
1.
Connect the plug end of the IR emitter cable to the
IR—NetCommand Output jack on the TV back panel.
2.
When the
New Device Found screen displays,
leave IR—NetCommand Output selected.
3.
EXIT and press ENTER.
Highlight
The New Device Found screen displays when you
connect the IR emitter.
4.
Position the emitter end with the emitter bulb facing
the device's remote control sensor. The bulb emits
infrared light in a cone-shaped pattern. Place the
bulb far enough from the sensor to allow the cone
pattern to reach the sensor.
In some cases, the emitter works better facing
downward from the top of the device. Experiment
to find what works best.
5.
Secure the emitter ends in place using double-
sided tape.
6.
Place any unused ends behind the devices to
prevent stray signals from reaching the IR sensors.
IMPORTANT
Position IR emitters so that each device's
sensor "sees" the signal from only one emitter.
Otherwise, a device receiving signals from
multiple sources (remote controls, IR emitters)
may not respond at all.
IR sensor
IR sensor
5. NetCommand IR Control
In front, shared by two
average-sized devices
Pr
Other A/V Device
A/V Receiver
Connecting IR–NetCommand Output
IR sensor
IR sensor
Place IR emitters so the signal can be "seen" by the IR
sensor on each device.
If You are Unable to Locate
a Device's IR Sensor
The IR sensor is usually behind the plastic window
of the front display panel. Using a flashlight, you
may be able to see it as a round or square cutout.
If you cannot see the sensor and the device's
Owner's Guide does not specify the location, do
the following using the device's remote control.
1.
Starting at one end of the plastic window, hold
the device's remote control about one-half
inch from the front of the device and press the
POWER key.
2.
If the device does not respond, move the
remote control one inch toward the center and
try again. Repeat until the device responds.
3.
Repeat the previous steps starting at the other
end of the window. The sensor will be between
these two points.
On top of a single tall
device
IR sensor
IR sensor
TV
In front of a single
average-sized device
On top of a single
tall device
In front, shared by
two average-sized
devices
53
AVR AUDIO OUTPUT
R
L
IR sensor
IR sensor
IR sensor

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Unisen lt-46151Unisen lt-46153Unisen lt-52151Unisen lt-40153Unisen lt-52153Unisen lt-46151 ... Show all

Table of Contents