Getting Started; How To Attach The Stylus; Installing The Rechargeable Battery Packs - VTech InnoTab 3S The Wi-Fi Learning Tablet User Manual

Battery Door Lock Sliding
Switches
microSD Memory Card Slot
Battery Compartments

How to Attach the Stylus

Tie one end of the stylus string to the stylus and the other end to the stylus
fastener on the InnoTab

Installing the Rechargeable Battery Packs

1. Make sure the InnoTab
2. Turn the unit over. Slide the battery door lock switches forward and push
the battery covers off to each side to remove them.
3. Insert Battery Pack① into the compartment on the right side and Battery
Pack② into the compartment on the left side.
• Insert the battery pack into the connector slot first.
• Then press the battery pack down until it rests in place.
4. Replace the battery covers.
Slide these switches to open the battery doors.
Always replace the InnoTab
after changing batteries.
Insert a microSD memory card (not included).
(NOTE: InnoTab
microSD memory cards up to 32GB.)
Insert 4 "AA" batteries (not included) or the
rechargeable battery packs. For battery installation
instructions, please see the section below.
3S.
®
3S is turned off.
®
3S battery doors
®
3S is compatible with
®
4