VTech InnoTab 3S The Wi-Fi Learning Tablet User Manual page 33

USB connection
window does not pop
up after connecting to
computer.
Clock time is not
accurate.
Touch screen is
inaccurate or it is
impossible to select
the correct icon on the
screen.
Inserted a microSD
memory card (not
included), but the tablet
cannot recognize it.
Files copied to the
tablet's internal memory
disappeared.
Cannot connect to
Wi-Fi.
Wi-Fi is On, but there
is no Wi-Fi network
available.
Poor USB cable
connection.
Connection is
running through
USB hub.
Backup battery
power low.
Touch screen
requires
calibration.
microSD memory
card format is
not FAT32.
The tablet's
memory was
not formatted to
FAT32.
The Wi-Fi is Off.
The firmware of
the InnoTab
®
3S is not up-
to-date or the
tablet has not
been registered
on Learning
Lodge .
TM
There is no
Wi-Fi network in
your location or
network signal is
weak.
Securely connect the USB cable to
InnoTab 3S and the computer.
®
Connect the InnoTab
the computer, without using a hub.
Replace backup battery (for backup
battery replacement instructions,
please see the Backup Battery
Replacement section on page 28).
Turn the InnoTab
®
, and
the InnoTab 3S ON. Follow the steps
®
on the screen.
Format the microSD memory card to
FAT32 in your computer.
If formatting the memory is
necessary, make sure it is formatted
to FAT32.
Go to Settings - Parent Settings - to
turn on Wi-Fi.
Register your tablet on Learning
Lodge , and make sure the firmware
TM
is the most up-to-date version. For
the instructions, please see the
Preparing to Use Wi-Fi section on
page 9.
Move to a location that has an
available Wi-Fi network.
3S directly to
®
3S OFF. Then hold
down when turning
30