Table of Contents
Advertisement
Open the right and left guides of the ADF paper chute about 5
mm wider than the document width.
Place the documents face down onto the ADF paper chute with
the top edges facing the automatic feeder hole.
Adjust the guides to the document sides. Skewing may occur if
there is a gap between the guides and documents.
Slide the documents down until they touch the far end of the
automatic feeder opening. If the documents hit the far end hard,
two or more pages may be fed at once. Make sure that the upper
end of documents are not turned.
Start the read operation. If a wrong document size or mode
11
(portrait or landscape) is selected, the document may not be read
entirely.
NOTICE:
Unless 3 mm of the leading edge of forms are not white or drop-
out color, set the document type to "Photo."
After reading, remove the documents from the stacker.
12
Guide
Automatic document feeder
Documents
ADF paper chute
Guide lever
Guide
Figure 4.4 Loading the document
Portrait
Landscape
Automatic document feeder
ADF paper chute
Documents
4 – 9
Advertisement
Table of Contents
