Chapter1 Preparing The Scanner; Checking The Contents Of The Scanner Package; Names Of Parts - Fujitsu fi-5900C Getting Started

Chapter1
1.1 Checking the Contents of
the Scanner Package
When you unpack the scanner package, make sure that
the package contains all the parts on the list included in
the package.
If any parts are missing or defective, contact your scan-
ner dealer or an authorized FUJITSU scanner service
provider. Handle the scanner and accessories with care.

1.2 Names of Parts

This section describes the names of parts.
■ Front side
2
1
7
8
9
10
11
12
No. Name
Prevents ejected documents from
1 Stopper
dropping off the scanner.
2 Stacker side For aligning ejected documents to
guide
a certain width.
3 Top cover Cover to access the consumables
storage box and Post Imprinter
option (sold separately).
4 Stacker Area where ejected paper collects
after scanning.
5 Ejector For ejecting the documents after
scanning.
6 Operator For operating the scanner.
panel
7 Stacker For scanning long documents. Pull
extension
the extension out according to the
document's length.
8 ADF cover Opens the cover for cleaning the
inner parts of the ADF or for
replacing consumables.
PREPARING THE SCANNER
3
4
5
6
15
14
13
Function
fi-5900C Image Scanner Getting Started
No. Name
9 ADF cover Button used to open the ADF
open button
10 Pre-imprinter For the Pre-Imprinter option
cover
11 ADF The documents loaded onto the
(Automatic Hopper will be fed sheet by sheet
document for scanning.
feeder)
12 Hopper Pulls the Hopper extension out for
loading long documents.
extension
13 Hopper Documents to be scanned are
loaded onto the Hopper.
14 Hopper side Sheet Guides used to make sure
guides that the paper to be scanned is fed
into the scanner straight, avoiding
skew.
15 Power button Switches the scanner ON&OFF.
■ Rear side
3 5
4
No. Name
1 Main power
switch
2 Power inlet
3 SCSI ID Switch
4 SCSI connector
5 USB connector
6 Extended mem-
ory slot
7 VRS slot
8 Extended slot
Function
7 8
6
Function
For switching the power support
ON/OFF.
For connecting the AC cable.
Sets the scanner's SCSI ID with
this switch.
For connecting the SCSI cable.
For connecting the USB cable.
For connecting an extension
memory (sold separately).
The VRS board has been
installed
A spare slot for an option board
1
2
1