Setting The Scsi Id And The Scsi Terminator - Fujitsu fi-4750L Operator's Manual
Image scanner
Hide thumbs
Also See for fi-4750L:
- Cleaning and maintenance (67 pages) ,
- Illustrated parts catalogue (25 pages) ,
- Brochure & specs (2 pages)
Table of Contents
Advertisement
Setting the SCSI ID and the SCSI Terminator
The default of the SCSI ID is 5. The SCSI ID is set by using the Setup mode of the operator panel. The
procedure to change the SCSI ID is as follows:
1 Turn the power On by
pressing the "I" side of the
power switch. The scanner
displays "Scanner Ready"
on the lower line of the LCD.
2 Press the "Next"
button.
The scanner displays "Mode
select 1".
NOTICE
If the scanner have a video interface option, the scanner displays "Mode Select 0" on the LCD.
3 Press the "Next"
button
again. The scanner displays
"Mode select 2" meaning
that the setup mode is
ready.
4 Press the "Enter" button.
The scanner displays the
following:
5 Press the "Next"
button
ten. The scanner displays
"SCSI ID" on the upper line
of the LCD.
6 Select the desired SCSI ID by pressing the "
ID is set.)
7 Press "Exit" to return to the "Scanner Ready" screen if you don't need to change the terminator.
NOTICE
If no other device is using the same SCSI ID, the scanner ID does not have to be changed.
NOTICE
The new ID does not take effect until the system power is turned On again.
"or "
" buttons, and then pressing "Enter" (the SCSI
2-7
Advertisement
Table of Contents
