Fujitsu fi-4750L Operator's Manual page 74

3. Setting IPC pre-set mode
When you set the use of the IPC pre-set mode, you must set it as follows:
1 Press "Next" or "Previous"
scanner display Screen 43.
2 At Screen 43, press
pre-Setting and press
pre-setting. Then the scanner displays
Screen 43-1.
NOTICES
The following 2PC pre-settings can be selected when 2PC-4D is installed:
Preset 1: Captures texts printed on the colored background
Preset 2: Produces an image with good contrast
Preset 3: OCR Smoothing
Preset 4: Image Smoothing
Preset 5: Dither
The following built-in IPC pre-settings can be selected even though IPC-4D is not installed:
• Sharpen
• Darken Character
• Copy Quality
3 At Screen 43-1, select "Yes" or "No". Note
that when you select "Yes", the IPC setting
from the Host computer is ignored. If you
select "No", the IPC setting will be changed
according to the host setting. Finally press
.
NOTICE
When you select the Copy Quality, select the scanner and printer settings carefully to get the best quality.
7-6
and let the
<Screen 43>
or to select the
to activate the
<Screen 43-1>