Crossfader Replacement - American Audio CK 800Mp3 User Manual

CROSSFADER REPLACEmENT

The crossfader is "Hot Swapable" which means it may be replaced at any time, even when power is
applied. Only replace with American Audio Part Feather Fader Plus. Replacing with any other model
fader may seriously damage your mixer.
Replacing the Crossfader:
1. Disconnect the systems main power supply
2. Using a Phillips screw driver, unscrew the six stainless steel retainer screws that hold the mixer
face plate in place.
3. Gently remove the channel fader knobs and crossfader knob. Lift the mixer face plate from its to
access the crossfader. Carefully pull the crossfader up from its seated position.
4. After removing the crossfader, disconnect the ribbon cable that attaches the crossfader to the
PC board. Grasp the crossfader by its base and pull the ribbon cable by its connector not the
actual cables. The connector is designed to only fit one way, so don't worry about the connec-
tors orientation.
5. Connect the new crossfader to the ribbon cable and replace in reverse order.
American Audio - www.AmericanAudio.us - CK 800Mp3 Instruction Manual Page 28
© ®