Repositioning The Shipping Lock - Fujitsu fi-4750C Operator's Manual

Repositioning the Shipping Lock

To keep the scanner from being damaged during shipping, the carrier unit is fixed with a Shipping Lock.
After placing the carrier unit where it will be installed, change the position of this Shipping Lock as
explained below.
Place the image scanner on the edge of the desktop so that the left side of the scanner (where the
1
ADF is attached) extends from the desktop. Do not set the image scanner upside down or on its
side.
CAUTION
Do not let the scanner hang more than 20 cm (8 in.) over the edge of the desk.
less than 20 cm
(8 in.)
Remove the shipping lock from position
2
Bottom view
Shipping Lock
(Position for storage,
position for shipment)
Enlarged section A
CAUTION
Before moving or storing the scanner, make sure that the shipping lock is set to the
shipment position to prevent possible damage. Before setting the shipping lock, make sure
that the carrier has been returned to the home position.
Good
Bad
. Then, install the shipping lock at position
A
Front side
Front side
ADF side
Bad
Enlarged
Shipping Lock
(Position for operation)
B
A
Shipping Lock
(Position for shipment)
.
B
2-3