Fujitsu fi-4750C Operator's Manual page 40

NOTICES
Note the following when preparing the paper.
• Remove paper clips and staples. Flatten the staple holes.
• Read the following documents using the Flatbed:
- Paper with clips or staples.
- Paper written on with wet ink.
- Paper of uneven thickness (for example, envelopes).
- Paper with large rumples or curls.
- Paper with folds or tears.
- Tracing paper.
- Coated paper.
- Carbon paper.
- Paper smaller than A8 (portrait) size or wider than A3 size.
- Materials other than paper (for example, clothes, sheet metal, or OHP film).
- Photographic paper.
- Paper with perforations on the side.
- Non-rectangular paper.
- Very thin paper.
• Set documents on the ADF so that the curl of the leading edge does not exceed the measures shown
below.
More than 30mm
Less than
3mm
Top of the paper
• To avoid skewing, do not feed docments of different widths during the same batch.
3
Adjust the stacker extension to the
paper size, and then flip out the plate.
3-6
Feed direction
Less than
5mm
Read surface
More than 30mm
Top of the paper
ADF paper chute
Stacker
Feed direction
Read surface