Electrolux EI30IF40LS Use And Care Manual page 15

Before Setting Oven Controls
Luxury Glide™ oven racks
IMPORTANT!
Remove ALL oven racks before starting a self clean cycle. If
oven racks are left inside the oven during a cleaning cycle, the
slide ability of the Luxury-Glide™ oven racks may be damaged
and all of the oven racks will lose their shiny finish.
Clean oven racks according to the instructions provided in the
Care & Cleaning section.
The fully extendable Luxury-Glide™ rack makes food prepara-
tion easier. This oven rack has glide tracks that allow the rack to
be pulled away from the oven without rubbing the sides of the
oven wall.
Removing and replacing the Luxury-Glide™
oven racks
To remove - Using one hand, reach through handle opening
and lift up on the release lever located across the lower front of
the rack as shown in
While holding up the release lever, pull the glide rack out of the
oven until the stop position is reached
hands, grasp the upper and lower portions of the glide rack. Lift
up the front of the rack slightly and continue to pull the rack
away from the oven
and lower rack portions together when removing or handling the
glide rack.
The rack portions move independently and are difficult to
handle unless held together.
To replace - grasp both upper and lower portions of glide rack,
lift and hold the rack level between the oven cavity walls. Tilt the
front of the rack upward slightly and slide the rack completely
into position. Some force may be necessary to make sure the
oven rack has snapped completely into place.
IMPORTANT!
To prevent possible damage to the oven, DO NOT attempt to
close the oven door until all the oven racks are fully positioned
back inside the oven cavity.
Figure 25.
(Figure 26). Using both
(Figure 27). Be sure to grasp both upper
Luxury-Glide™ extendable oven
rack
release
lever
Figure 25: Luxury-Glide™ rack and release lever
Figure 26: Gripping release lever and sliding rack
Figure 27: Removing the Luxury-Glide™ rack
15
upper rack
portion
lower rack
portion